On Fri, May 07, 2004 at 10:45:13AM -0400, Rick Beasley wrote: > PROBLEM: My x100p only does bad things. When I plug the line from the > wall into the card, other phones in my house go nuts, no dialtone, crazy > clicking, random tones, etc. Following the steps below, the line is > screwed up any time I test after step 2. Just plugging the line from the > wall into the x100p takes my other phones off line. External calls to my > line hear busy. Obviously, can't do the first testing with asterisk+x100p. > > 1. Installed asterisk > 2. Installed card in slot (no shared IRQs) > 3. Installed (modprobed) drivers > 4. Modified config files to just basics for my environment > 5. Ran ztcfg > 6. Started asterisk > > No errors, asterisk starts fine, modprobe -q shows drivers. Next I'm > going to experiment with "context" since I've seen several > recommendations including incoming and bell.
This sounds like a hardware error, not software. Change the line cord from the FXO port to the wall. If that doesn't make a difference, change jacks. Try that jack with another phone. Tim -- >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< >> Tim Sailer >< Coastal Internet, Inc. << >> Network and Systems Operations >< PO Box 726 << >> http://www.buoy.com >< Moriches, NY 11955 << >> [EMAIL PROTECTED] >< (631) 399-2910 IAX 17003992910 << >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<< _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
