I make it compile. I just never finished it. :-)
What I did to make R2 work properly was throw away the code that is now in CVS at Digium, and write a new implementation from scratch. I guess that is not quite the answer you wanted to hear. :-(
Regards, Steve
Jorge Verastegui wrote:
Hi
I know there is no support for R2, but I succcessfully compiled and ran
the libr2. However, I am not able to initiate calls.
The error I get is
Couldn't call g3/71605538 -- Hungup 'Zap/32-1' == Everyone is busy at this time
I understand that the idle signaling is not working right, any ideas on what I can do to fix this problem?
Looking forward to your responses.
Regards,
Jorge
On Fri, 2004-04-30 at 22:58, Steve Underwood wrote:
jorge verastegui wrote:
HiThis error is easy to fix by changing ccs to cas, and removing crc4, in your zaptel.conf file. However libr2 does not work. It is a partly implemented solution which I abandoned. It only gets you about 10% of the way to a working R2 system :-(
i have successfully downloaded and compiled libr2 from source.
But i dont seem to find how to properly configure it. When i run it (partcially unconfigured) the following error occurrs
Signalling requested is R2 Signalling but line is in PRI Signalling signalling
My current R2 software is completely different.
Regards,
Steve
] _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
