I'm sure you can, but I've never done it.
On 12/7/20 2:18 PM, [email protected] wrote:
Sound reasonable. I know it take time to debug the dial-plan after upgrade.
Can I use sipp, from command line to call my local asterisk specific
extension and to observe in another terminal via "asterisk -vvvvvvr"
what it is doing?
On 12/07/2020 11:50 AM, Eric Wieling wrote:
Read UPGRADE.TXT in v13 and v16. Then read it again.
I upgraded from Asterisk v11 to Asterisk v13. Once all issues were
resolved, then I switched to PJSIP. Once all the issues with PJSIP
were resolved, then I upgraded from v13 to Asterisk v16. This was done
over the course of about a year, but I was not in any hurry.
PJSIP configuration is fundamentally different chan_sip configuration. I
don't recommend switching to PJSIP and upgrade Asterisk at the same time.
On 12/6/20 3:38 PM, [email protected] wrote:
I'm planning to upgrade my asterisk-11.25 to ver. 13
or should I go to 11 to 16
Is there any official documentation how to upgrade, what to watch for
during upgrade?
--
http://help.nyigc.net/
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
Check out the new Asterisk community forum at: https://community.asterisk.org/
New to Asterisk? Start here:
https://wiki.asterisk.org/wiki/display/AST/Getting+Started
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
