Hello,
You can certainly do this with the ARI interface but you will have to
write some code.
You could for example originate two channels, send them to the same
Stasis application, create a bridge and place both channels in it.
Best regards
Jean Aunis
Le 26/06/2017 à 14:06, Harel a écrit :
Hello List,
I'm working on an autodialer project.
At the moment I use the Originate application then I "throw" it to an extension
where I Dial() the other party and then both legs are bridged. The problem is that the
Dial() will only run after the Originate finish its bit and I have lots of wasted time or
even worse, the remote party hanging the call because instead of a human speaking to him
the call setup to the 2nd leg only starts when remote answers.
Is there a way to start calling both parties at the same time and bridge them
when one answers (which will then hear the ringback tone until 2nd party
answers)?
Thank you
Harel
--
_____________________________________________________________________
-- Bandwidth and Colocation Provided by http://www.api-digital.com --
Check out the new Asterisk community forum at: https://community.asterisk.org/
New to Asterisk? Start here:
https://wiki.asterisk.org/wiki/display/AST/Getting+Started
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
