Hi,
I'm trying to get my X100P to Dial the following sequence to gain access to
speed dial numbers on my Norstar PBX that the X100 is connected to...
[FLASH] [*] [0] [22] (where 22 is the speed dial number)
But so far I've had no luck, with the following extension:-
exten => 922,1,Flash(${DIALOUTANALOG})
exten => 922,2,Dial(${DIALOUTANALOG}/*022)
exten => 922,3,Congestion
exten => 922,4,Hangup
Looking at the console, Asterisk doesn't get past the Flash command, telling
me that it's not a valid Zap channel. The call is being made from my Cisco
SIP phone through my local Asterisk Box, then via an IAX2 channel to the
site with the Asterisk box+X100P connected to the Norstar.
====CONSOLE LOG====
-- Accepting AUTHENTICATED call from 192.168.1.1, requested format = 2,
actual format = 2
-- Executing Flash("[EMAIL PROTECTED]/2", "Zap/1") in new stack Feb 3
22:37:19 WARNING[1146896]: app_flash.c:85 flash_exec:
[EMAIL PROTECTED]/2 is not a Zap channel
== Spawn extension (local, 922, 1) exited non-zero on
'[EMAIL PROTECTED]/2'
-- Hungup '[EMAIL PROTECTED]/2'
====CONSOLE LOG====
Is there some other way to dial a flash with the dial command? I notice
there's a W to insert a wait sequence.
Thanks,
Chris Lee
_______________________________________________
Asterisk-Users mailing list
[EMAIL PROTECTED]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
