Hi,
I tested the capi_chan with latest cvs of * and I have problems with
Early-B3. The following dialstring works for me (without Early B3):
exten => _0X.,1,Dial(CAPI/@22715291:${EXTEN:1}|30)
But if I add the 'b' for using Early-B3
exten => _0X.,1,Dial(CAPI/@22715291:b${EXTEN:1}|30)
nothing changes (no dialtone). If in this example the called party
discards the call, there is no signalling to my SIP-Phones. In this case
"capi debug" tells a lot of:
--------
-- CONNECT_B3_ACTIVE_IND ID=001 #0xb2f4 LEN=0013
Controller/PLCI/NCCI = 0x10101
NCPI = default
> sent CONNECT_B3_ACTIVE_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
> sent DATA_B3_RESP (NCCI=0x10101)
... until I stop the call from SIP phone (the originating site)
-- CAPI Hangingup
> activehangingup
> sent DISCONNECT_B3_REQ NCCI=0x10101
-- DISCONNECT_B3_CONF ID=001 #0x001a LEN=0014
Controller/PLCI/NCCI = 0x10101
Info = 0x0
== DISCONNECT_B3_IND NCCI=0x10101
> sent DISCONNECT_B3_RESP NCCI=0x10101
> sent DISCONNECT_REQ PLCI=0x101
-- DISCONNECT_CONF ID=001 #0x001b LEN=0014
Controller/PLCI/NCCI = 0x101
Info = 0x0
== DISCONNECT_IND PLCI=0x101 REASON=0x3495
> sent DISCONNECT_RESP PLCI=0x101
-- removed pipe for PLCI = 0x101
-------
Hardware is a AVM-B1 (active BRI card)
What am I doing wrong, or where can I start debugging?
Thanks,
Karsten
_______________________________________________
Asterisk-Users mailing list
[EMAIL PROTECTED]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
