2009/12/4 Tzafrir Cohen <[email protected]> > On Fri, Dec 04, 2009 at 02:42:18PM +0100, Olivier wrote: > > Hi, > > > > I'm using revision 6822 of Dahdi Tools. > > > > # dahdi_hardware > > pci:0000:05:06.0 wcb4xxp+ d161:b410 Digium Wildcard B410P > > > > # asterisk -rx "dahdi show version" > > DAHDI Version: 2.2.0.2 Echo Canceller: OSLEC > > > > # cat /etc/dahdi/genconf_parameters > > ... > > pri_termtype > > SPAN/1 TE > > SPAN/2 TE > > SPAN/3 NT > > SPAN/4 NT > > With BRI cards dahdi_genconf assumes that it uses whatever the card is > jumpered for. >
OK but I'm quite certain I set each jumper this way : jumper 1 and 2 in TE mode, 3 and 4 in NT modes with termination). How can I further check jumpers are correctly "read" ? As it worked correctly after I hand edited system.conf and dahdi-channels.cont with appropriate values and I connected port 1 to port 4 (and port 2 to 3), I would say there might an issue in card jumper detection. > -- > Tzafrir Cohen > icq#16849755 > jabber:[email protected]<jabber%[email protected]> > +972-50-7952406 mailto:[email protected] > http://www.xorcom.com iax:[email protected]/tzafrir > > _______________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users >
_______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
