Hello, now I can reset and load the firmware, but I do not see the entries in /proc and the genzaptel command ignores the astribank. The dual PRI card works fine.
r...@pbx1:~# zaptel_hardware usb:002/002 xpp_usb- e4e4:1161 Astribank-modular USB-firmware pci:0000:01:05.0 wct4xxp+ d161:0210 Wildcard TE210P r...@pbx1:~# ls /proc/zaptel/* /proc/zaptel/1 /proc/zaptel/2 Best regards, Loïc. On Fri, 2009-09-25 at 20:01 +0300, Tzafrir Cohen wrote: > On Fri, Sep 25, 2009 at 04:30:19PM +0200, Loic Didelot wrote: > > # lsusb > > Bus 002 Device 003: ID e4e4:1160 > > Bus 002 Device 001: ID 0000:0000 > > Bus 001 Device 003: ID 0403:e6c8 Future Technology Devices > > International, Ltd > > Bus 001 Device 002: ID 0403:6001 Future Technology Devices > > International, Ltd FT232 USB-Serial (UART) IC > > Bus 001 Device 001: ID 0000:0000 > > # ls /proc/bus/usb -a > > . .. > > Add the following line to /etc/fstab: > > procbususb /proc/bus/usb usbfs defaults 0 0 > > > Then run: > > mount /proc/bus/usb > > (or: 'mount -a') > > Once that is in place, either disconnect and reconnect the Astribank, or > use: > > /usr/share/dahdi/xpp_fxloader usb > _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- AstriCon 2009 - October 13 - 15 Phoenix, Arizona Register Now: http://www.astricon.net asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
