This is probably cold comfort but I have NEVER had any issues with MWI working on Aastra phones. It always just works by default. No extra configuration necessary on the phone for sure. Just reset it to factory defaults. Explicit MWI is NOT checked by default and I have never had to check it.
No extra configuration on Freepbx/Trixbox. Not sure about a basic Asterisk install but here is my sip.conf. [general] bindport = 5060 ; Port to bind to (SIP is 5060) bindaddr = 0.0.0.0 ; Address to bind to (all addresses on machine) disallow=all allow=ulaw allow=alaw ; If you need to answer unauthenticated calls, you should change this ; next line to 'from-trunk', rather than 'from-sip-external'. ; You'll know this is happening if when you call in you get a message ; saying "The number you have dialed is not in service. Please check the ; number and try again." context = from-sip-external ; Send unknown SIP callers to this context callerid = Unknown tos=0x68 ; #, in this configuration file, is NOT A COMMENT. This is exactly ; how it should be. #include sip_nat.conf #include sip_custom.conf #include sip_additional.conf [600] type=friend secret=xxx record_out=Adhoc record_in=Adhoc qualify=yes port=5060 nat=no [EMAIL PROTECTED] host=dynamic dtmfmode=rfc2833 disallow=all dial=SIP/600 context=from-internal canreinvite=no callerid=device <600> allow=ulaw -----Original Message----- From: Lee Jenkins [mailto:[EMAIL PROTECTED] Sent: Monday, May 21, 2007 11:40 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: [asterisk-users] Aastra MWI I need to setup MWI on a few Aastra 9112's. I've tried doing so in the web interface by setting "Explicit MWI Subscription" to true, but no lights, no stutter tone. Firmware: 1.4.0.1048 Thanks! -- Warm Regards, Lee _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
