I am using an Sipura 3000 here and it is working (mostly) fine but I had a lot of learning to do in the beginning. I missed the original question and problem?? Perhaps you could state that again of refer me to it? Keep in mind there are two major firmware versions for the 3000. Version 2 and 3. In version 2 you have to do some extra stuff to get it to allow Asterisk to answer. In version 3 there is an option to allow it to pass the ringing call to Asterisk which makes it a lot easier. when doing this you need to set the delay such that at least 1-2 rings are received before you do this or the CID does not get passed properly. I have it set to 4 or 4 seconds as I recall.
The version 3 firmware IS useaable on the version 2 hardware. I am using it here. I did find that an earlier version 3 firmware had better echo cancelation then the lastest version though. Actually the version 2 firmware was even better but lacking the option to have Asterisk answer the phone, so I opted for the compromise. I would be glad to send my settings it you like. My HW version is 2.0.1 and firmware is 3.1.3 The Sipura site only has the latest version 3 - 3.1.10 I believe. There is an (australian?) site that has all the past versions available for download. Google for it. Doug "Those that sacrifice essential liberty to obtain a little temporary safety deserve neither liberty nor safety." -- Ben Franklin (1759) **************************** * Doug Crompton * * Richboro, PA 18954 * * 215-431-6307 * * * * [EMAIL PROTECTED] * * http://www.crompton.com * **************************** _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
