helleo ,I have one wildcard installed on the server,and configured it.there
are
two modules which both FXOs .all configurations complete,and when we start
asterisk use "asterisk -vvvvc",it shows asterisk ready,no warnings.afterwards
when the sever connected to the PSTN in the one port which configured,and have
a phone line connected to the other port then run "zttool",however it shows
just one channel active.I can't understand ,why? I try to dial the PSTN number
from another external phone to test,but the call is not ringing.But in the
asterisk cLI there are some infos following as :
-- Starting simple switch on 'Zap/4-1'
-- Executing Dial("Zap/4-1", "Zap/g1") in new stack
those are my configurations:
-extension.conf--
[incoming]
exten => s,1,Answer()
exten => s,2,Echo()
-zapata.conf--
context=incoming
signalling=fxs_ks
channel => 3-4
-zaptel.conf
context=incoming
signalling=fxs_ks
channel => 3-4
hope to hear from you
thanks & regards
--
This message was sent on behalf of [EMAIL PROTECTED] at openSubscriber.com
http://www.opensubscriber.com/messages/[email protected]/topic.html
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
