> I am running 2 TDM400's in a single machine without a drama. It is a > scenario that will work, but you have to be careful with your PCI slots > and IRQ assignments. I basically disabled everything on board that was > not needed (USB, floppy, IDE2 etc) and had to play around with which > slot the cards went in to ensure that neither of the TDM cards were > sharing resources with something else like the on board eth controller.
>From what I understand about the way the TDM400 cards work, it may be possible to disable the interrupt on one card and service both cards on the remaining interrupt. There may be some extra (hardware?) synchronisation required between the two cards, which would make the idea a bit less attractive. This only solves the problem of interrupt availability/sharing though, not the fact that you still have to do approximately the same amount of work per interrupt. James _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
