I have looked
through other postings to the user group for HDLC errors, went through what
worked for other people, and still can not seem to get past this
issue.
For 3 days, I have
been getting HDLC abort(6) errors in *. Prior to Tuesday, the circuits were
clean...I had maybe 10 HDLC abort messages since August
10th.
Here are my
specs:
1 Gig IBM x300 w/ 1
Gig Ram
1 Quad TE405P
card
No errors on
IRQs
IRQs are separated
with NO sharing
hdparm for irq and
dma are set to 'on'
Software -
FC1 with -1 updates
to kernel, etc.
Asterisk v 1.0.9,
libpri 1.0.9, zaptel 1.0.9.2
1 T1 is a tieline to
our Nortel Meridian
3 T1s are a PRI
trunk group with D chans on 24 and 48. The third T1 only has b
channels.
No alarms from
zttool.
Calls go through,
inbound and outbound.
About every 5
seconds, I get the following on the console:
Nov 4 21:10:37
NOTICE[9693]: PRI got event: Alarm (4) on Secondary D-channel of span
1
Nov 4 21:10:37 NOTICE[9693]: PRI got event: HDLC Abort (6) on Primary D-channel of span 1
Nov 4 21:10:37 NOTICE[9693]: PRI got event: HDLC Abort (6) on Primary D-channel of span 1
The errors seem to
increase as calls come in and out. There is also a noticable "popping" when the
error happens.
Any suggestions are
welcome.
thank
you
Jason
_______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list [email protected] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
