|
It flashes red until the properly made cables are
connected and then should turn to solid green. Again, I suspect your
cable is the issue. Are all the drivers loaded? ztcfg?
Asterisk running? One span set to pri_cpe and the other to
pri_net?
----- Original Message -----
Sent: Wednesday, September 28, 2005 6:47
PM
Subject: Re: [Asterisk-Users] TE205P in
loopback?
The board flashes red without cables and continues flashing red after
cables are connected. Should it flash green before? I don't see anything weird
in dmegs results.
From: "Steve Totaro" <[EMAIL PROTECTED]>
Reply-To:
Asterisk Users Mailing List - Non-Commercial Discussion<[email protected]>
To:
"Asterisk Users Mailing List - Non-Commercial
Discussion"<[email protected]>
Subject: Re:
[Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep 2005
21:12:08 -0700
If the cables are connected and the lights are
still flashing red then I suspect that the cable is the issue.
----- Original Message -----
Sent: Wednesday, September 28, 2005
5:44 PM
Subject: Re: [Asterisk-Users] TE205P
in loopback?
I did the cable and configuration as recomended, but I may have
another problem. After I run:
modprobe zaptel
modprobe wct2xxp
I don't see the boards flashing green it's flashing red and in sync, as
I implicitly understand from your message . Should it flash green and
when correctly cabled and configured, keep green?
How can I debug this?
any help is appreciated.
-f
From: "Steve Totaro"
<[EMAIL PROTECTED]>
Reply-To: Asterisk
Users Mailing List - Non-Commercial
Discussion<[email protected]>
To:
"Asterisk Users Mailing List - Non-Commercial
Discussion"<[email protected]>
Subject:
Re: [Asterisk-Users] TE205P in loopback?
Date: Wed, 28 Sep
2005 20:12:40 -0700
I just did this on a te410p.
make a t1 crossover, cross pins one with
four, and two with five. Set one span for pri_cpe and the
other side for pri_net. boom, you are done and can start
testing. the lights should turn solid green and you
should first see the D channels come up and then all
the B channels, if this happens, you have done it
correctly.
thanks,
Steve
----- Original Message -----
Sent: Wednesday, September 28,
2005 4:46 PM
Subject: [Asterisk-Users] TE205P
in loopback?
I'm a new * user and had just intalled A TE205P line in my Linux
machine (running linux kernel 2.6.10). I would like to test the T1
interface but I don't have an ISDN PRI interface available right now.
Is there a way to make some sort of loopback test? How to configure
it? Do I need the cables to have tx/rx exchanged?
Any help would be appreciated.
- f
_______________________________________________
--Bandwidth
and Colocation sponsored by Easynews.com --
Asterisk-Users
mailing
list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To
UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
No virus found in this incoming message.
Checked by AVG
Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 -
Release Date: 9/27/05
>_______________________________________________
>--Bandwidth
and Colocation sponsored by Easynews.com
--
>
>Asterisk-Users mailing
list
>[email protected]
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To
UNSUBSCRIBE or update options visit:
>
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and
Colocation sponsored by Easynews.com --
Asterisk-Users mailing
list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To
UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
No virus found in this incoming message.
Checked by AVG
Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release
Date: 9/27/05
>_______________________________________________
>--Bandwidth
and Colocation sponsored by Easynews.com --
>
>Asterisk-Users
mailing
list
>[email protected]
>http://lists.digium.com/mailman/listinfo/asterisk-users
>To
UNSUBSCRIBE or update options visit:
>
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and
Colocation sponsored by Easynews.com --
Asterisk-Users mailing
list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To
UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
No virus found in this incoming message.
Checked by AVG
Anti-Virus.
Version: 7.0.344 / Virus Database: 267.11.8/113 - Release Date:
9/27/05
|
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
