Could someone elaborate on this a little? I wasn't aware that this was necessary.
Quoting Steve Haehnichen <[EMAIL PROTECTED]>: > I'm a newbie, not afraid to admit it. I tried to install my TDM400P > without the auxilliary (drive) power connection and got this failure > when loading the wcfxs module: > > Freshmaker version: 63 > Freshmaker passed register test > ProSLIC on module 0 failed to powerup within 510 ms > Unable to do INITIAL ProSLIC powerup on module 0 > Module 0: Not installed > Module 1: Not installed > Module 2: Not installed > Module 3: Not installed > > A search of the archives turned up nothing, so hopefully it will show > this message now. :) > > Apparently, this is what happens if a power cable is not connected to > the side of the card. I added that connection, and now it probes > normally: > > Freshmaker version: 63 > Freshmaker passed register test > Module 0: Initialized > Module 1: Not installed > Module 2: Not installed > Module 3: Not installed > Found a Wildcard FXS: Wildcard TDM400P REV E (4 modules) > Registered tone zone 0 (United States / North America) > > There was probably a memo somewhere explaining the power socket, but I > didn't get it. > > -Steve > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
