You might be experiencing a PCI Master Abort. Type dmesg. If you see PCI Master Abort, then that is your problem. If you don't, then I'm out of ideas.
-Derek -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Brad Bergman Sent: Thursday, July 10, 2003 11:52 AM To: [EMAIL PROTECTED] Subject: [Asterisk-Users] TDM10B - Dies after a few hours I've been having trouble with a TDM10B that I installed a few days ago. At first I could not modprobe it at all (getting the errors below). I switched the X100P that was also installed (with a Motorola chip) with one with a Tiger-something chip, and then everything starts up okay. However, after a few hours, the FXS port dies (no battery or anything), and if I try to rmmod & modprobe again, I can't. modprobe wcfxs /lib/modules/2.4.18-14/misc/wcfxs.o: init_module: No such device Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters. You may find more information in syslog or the output from dmesg /lib/modules/2.4.18-14/misc/wcfxs.o: insmod /lib/modules/2.4.18-14/misc/wcfxs.o failed /lib/modules/2.4.18-14/misc/wcfxs.o: insmod wcfxs failed I have seen a couple of references to this or similar problems, but no solution... http://lists.digium.com/pipermail/asterisk-users/2003-May/011171.html http://lists.digium.com/pipermail/asterisk-users/2003-May/012891.html Anyone have any ideas? I realize that there are some problems with the board in general, but this one doesn't really seem similar. Thanks, Brad _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
