You could configure the channels of port 1 as clear=1-24 in zaptel.conf This way you'll have one big pipe on /dev/zap/1 accessible for you. Unfortunatelly you cannot do clear=1-96 and have it all 4 spans on /dev/zap/1.
regards Martin On Thu, 3 Apr 2003, Chris Albertson wrote: > > Is there a block diagram or similar for the T400P? > What about programming information? What documentation > exists for it that a device driver writter might want? > > I need a T1 interface for a non-telephony application. > All I need to do is get the raw bits into a computer > > The application is this: > > A radio telemetry system sends a bit stream to a reciever > the reciever recovers the clock but not word boundries > it then puts this uninterpeted bit stream on one end of > a T1. ...(lots of detail omitted here.)... > At the other end we use "a bunch of equipment" to > get this data into a format usable by computers. I'd like > to replace this "bunch of equipment" with a PC, some > kind of a T1 interface card and some software. The more > basic and programable the T1 interface card the better as > the data is unconventional (from the viewpoint of a > PC) and might contain 12, 6, or 10 bit bytes mixed in > the same bit stream. Sometimes the bit stream is multiplexed > over multiple T1s. So I do _not_ need the T1 interface > card to do any protocol, just pass the bits. > > > ===== > Chris Albertson > Home: 310-376-1029 [EMAIL PROTECTED] > Cell: 310-990-7550 > Office: 310-336-5189 [EMAIL PROTECTED] > KG6OMK > > __________________________________________________ > Do you Yahoo!? > Yahoo! Tax Center - File online, calculators, forms, and more > http://tax.yahoo.com > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
