looks like ser is not accepting the call or similar, checkout the 'ngrep' command and listen for incoming packets on the ser-port respectively ip/machine:
ngrep -W byline port 5060 or ngrep -W byline host xxx.xxx.xxx.xxx if you can't find the problem with this debug, you should go to the users-list to ask your question(this list is intended for the development of asterisk, not its configuration) regards christian On Sat, 27 May 2006 11:44:12 -0300 "Sebastian Milioto" <[EMAIL PROTECTED]> wrote: > Hi all, > > I hava SER with many clients (sipura SPA2100). One of these is an > Asterisk which have others clients (sipuraSPA2100). > I also have a Cisco GW which give me access to the PSTN. > I make calls to all IP phones in my network, but I can't call PSTN > numbers. After I dial, I hear 2 ringbacks but at the same time > Asterisk says: > > Called [EMAIL PROTECTED] > SIP/SER_ip_address-ec75 is circuit-busy > Everyone is busy/congested at this time (1:0/1/0) > > Then I hear busy tone. > > I tried thousands of parameters. (Ovbiously not the correct one :-s ) > Any body could help me with this? > > Thanks very much in advance > > Sebastian > _______________________________________________ > --Bandwidth and Colocation provided by Easynews.com -- > > asterisk-dev mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-dev _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-dev mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-dev
