Recently we introduced a patch for fixing an MST issue, but it caused a
regression on Club 3D since we could not set a refresh rate higher than
60Hz. This commit fixes this issue by adding a proper check after
validating the stream.
Fixes: 1bd038dc60e3 ("drm/amd/display: add mst port output bw check")
Reviewed-by: Hersen Wu <[email protected]>
Acked-by: Rodrigo Siqueira <[email protected]>
Signed-off-by: Rodrigo Siqueira <[email protected]>
---
drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
index 5d150f85e1d5..7642411ec6db 100644
--- a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
+++ b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
@@ -7210,12 +7210,10 @@ create_validate_stream_for_sink(struct
amdgpu_dm_connector *aconnector,
break;
}
- if (stream->signal == SIGNAL_TYPE_DISPLAY_PORT_MST)
+ dc_result = dc_validate_stream(adev->dm.dc, stream);
+ if (dc_result == DC_OK && stream->signal ==
SIGNAL_TYPE_DISPLAY_PORT_MST)
dc_result = dm_dp_mst_is_port_support_mode(aconnector,
stream);
- if (dc_result == DC_OK)
- dc_result = dc_validate_stream(adev->dm.dc, stream);
-
if (dc_result != DC_OK) {
DRM_DEBUG_KMS("Mode %dx%d (clk %d) failed DC validation
with error %d (%s)\n",
drm_mode->hdisplay,
--
2.25.1
