From: Dmytro Laktyushkin <[email protected]> A previous odm change broke stream enable by always setting n_multiply as if odm was on.
This fixes the check for odm by making sure opp count is >1 rather than not 0. Signed-off-by: Dmytro Laktyushkin <[email protected]> Reviewed-by: Charlene Liu <[email protected]> Acked-by: Bhawanpreet Lakha <[email protected]> --- drivers/gpu/drm/amd/display/dc/dcn20/dcn20_hwseq.c | 4 ++-- drivers/gpu/drm/amd/display/dc/dcn20/dcn20_stream_encoder.c | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_hwseq.c b/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_hwseq.c index aee624371728..87ba8efc51ab 100644 --- a/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_hwseq.c +++ b/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_hwseq.c @@ -1585,10 +1585,10 @@ void dcn20_unblank_stream(struct pipe_ctx *pipe_ctx, params.link_settings.link_rate = link_settings->link_rate; if (dc_is_dp_signal(pipe_ctx->stream->signal)) { - if (optc1_is_two_pixels_per_containter(&stream->timing) || params.opp_cnt) + if (optc1_is_two_pixels_per_containter(&stream->timing) || params.opp_cnt > 1) params.timing.pix_clk_100hz /= 2; pipe_ctx->stream_res.stream_enc->funcs->dp_set_odm_combine( - pipe_ctx->stream_res.stream_enc, params.opp_cnt); + pipe_ctx->stream_res.stream_enc, params.opp_cnt > 1); pipe_ctx->stream_res.stream_enc->funcs->dp_unblank(pipe_ctx->stream_res.stream_enc, ¶ms); } diff --git a/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_stream_encoder.c b/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_stream_encoder.c index 488fb5c71dd0..2ed3b561ebbd 100644 --- a/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_stream_encoder.c +++ b/drivers/gpu/drm/amd/display/dc/dcn20/dcn20_stream_encoder.c @@ -466,7 +466,7 @@ void enc2_stream_encoder_dp_unblank( uint64_t m_vid_l = n_vid; /* YCbCr 4:2:0 : Computed VID_M will be 2X the input rate */ - if (is_two_pixels_per_containter(¶m->timing) || param->opp_cnt) { + if (is_two_pixels_per_containter(¶m->timing) || param->opp_cnt > 1) { /*this logic should be the same in get_pixel_clock_parameters() */ n_multiply = 1; } -- 2.17.1 _______________________________________________ amd-gfx mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/amd-gfx
