Dear community,
I hope this is the right adress for my question, because it's not so
much about alsa but about jack and firewire.
I'm using Ubuntu Oneiric and I have a firewire soundcard, the edirol fa-66.
I have installed jackd1, which includes the ffado-drivers for firewire modules.
Off course I have clicked the "enable raw1394 access" in the ubuntu
studio controls.
When I start qjackctl with the firewire drivers, it stops immediately.
I can read in the message window of qjack:
cannot load driver module firewire
When I type
ls -al /dev/raw1394
and sudo chmod 777 /dev/raw1394
I get
ls: Zugriff auf /dev/raw1394 nicht möglich: Datei oder Verzeichnis
nicht gefunden
(in english: can't get acess do /dev/raw139, file or folder not found)
Somewhere I have read the one should do:
sudo ln -s /dev/fw0 /dev/raw1394
After that I get for ls -al /dev/raw1394
lrwxrwxrwx 1 root root 8 2012-01-25 08:46 /dev/raw1394 -> /dev/fw0
But I have still the same problem!
Jack "says" always
loading driver ..
SSE2 detected
libffado 2.999.0- built Oct 10 2011 08:11:23
firewire ERR: Error creating FFADO streaming device
cannot load driver module firewire
But a few months ago everything worked excellent!
Does somenone have an idea, which could be the first step in solving my problem?
The output of ffado-diag says
FFADO diagnostic utility 2.999.0-
============================
(C) 2008 Pieter Palmers
2009-2010 Arnold Krille
=== CHECK ===
Base system...
kernel version............ 3.0.0-15-generic
old 1394 stack present.... False
old 1394 stack loaded..... False
old 1394 stack active..... False
new 1394 stack present.... True
new 1394 stack loaded..... True
new 1394 stack active..... True
/dev/raw1394 node present. False
Prerequisites (dynamic at run-time)...
gcc ............... gcc (Ubuntu/Linaro 4.6.1-9ubuntu3) 4.6.1
g++ ............... sh: g++: not found
PyQt4 (by pyuic4) . sh: pyuic4: not found
jackd ............. jackd version 0.121.0 tmpdir /dev/shm protocol 24
path ............ /usr/bin/jackd
flags ........... Package jack was not found in the
pkg-config search path.
Perhaps you should add the directory containing `jack.pc'
to the PKG_CONFIG_PATH environment variable
No package 'jack' found
libraw1394 ........ 2.0.7
flags ........... -lraw1394
libavc1394 ........ Package libavc1394 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libavc1394.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libavc1394' found
flags ........... Package libavc1394 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libavc1394.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libavc1394' found
libiec61883 ....... Package libiec61883 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libiec61883.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libiec61883' found
flags ........... Package libiec61883 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libiec61883.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libiec61883' found
libxml++-2.6 ...... Package libxml++-2.6 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libxml++-2.6.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libxml++-2.6' found
flags ........... Package libxml++-2.6 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `libxml++-2.6.pc'
to the PKG_CONFIG_PATH environment variable
No package 'libxml++-2.6' found
dbus-1 ............ Package dbus-1 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `dbus-1.pc'
to the PKG_CONFIG_PATH environment variable
No package 'dbus-1' found
flags ........... Package dbus-1 was not found in the
pkg-config search path.
Perhaps you should add the directory containing `dbus-1.pc'
to the PKG_CONFIG_PATH environment variable
No package 'dbus-1' found
Prerequisites (static at compile-time)...
gcc ............... gcc (Ubuntu/Linaro 4.6.1-9ubuntu3) 4.6.1
g++ ............... g++ (Ubuntu/Linaro 4.6.1-9ubuntu3) 4.6.1
PyQt4 (by pyuic4) . Python User Interface Compiler 4.8.5 for Qt
version 4.7.3
jackd ............. sh: jackd: not found
path ............
flags ........... Package jack was not found in the
pkg-config search path.
libraw1394 ........ 2.0.7
flags ........... -lraw1394
libavc1394 ........ Package libavc1394 was not found in the
pkg-config search path.
flags ........... Package libavc1394 was not found in the
pkg-config search path.
libiec61883 ....... 1.2.0
flags ........... -liec61883 -lraw1394
libxml++-2.6 ...... 2.34.1
flags ........... -pthread -I/usr/include/glib-2.0
-I/usr/lib/x86_64-linux-gnu/glib-2.0/include
-I/usr/include/libxml++-2.6 -I/usr/lib/libxml++-2.6/include
-I/usr/include/libxml2 -I/usr/include/glibmm-2.4
-I/usr/lib/glibmm-2.4/include -I/usr/include/sigc++-2.0
-I/usr/lib/sigc++-2.0/include -pthread -lxml++-2.6 -lxml2
-lglibmm-2.4 -lgobject-2.0 -lsigc-2.0 -lgthread-2.0 -lrt -lglib-2.0
dbus-1 ............ 1.4.14
flags ........... -I/usr/include/dbus-1.0
-I/usr/lib/x86_64-linux-gnu/dbus-1.0/include -ldbus-1 -lpthread -lrt
Hardware...
Host controllers:
03:00.3 FireWire (IEEE 1394) [0c00]: Ricoh Co Ltd FireWire Host
Controller [1180:e832] (prog-if 10 [OHCI])
Subsystem: Sony Corporation Device [104d:907a]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B- DisINTx+
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin D routed to IRQ 55
Region 0: Memory at e7a01000 (32-bit, non-prefetchable) [size=2K]
Capabilities: <access denied>
Kernel driver in use: firewire_ohci
Kernel modules: firewire-ohci
CPU info:
Architecture: x86_64
CPU op-mode(s): 32-bit, 64-bit
Byte Order: Little Endian
CPU(s): 8
On-line CPU(s) list: 0-7
Thread(s) per core: 2
Core(s) per socket: 4
CPU socket(s): 1
NUMA node(s): 1
Vendor ID: GenuineIntel
CPU family: 6
Model: 30
Stepping: 5
CPU MHz: 933.000
BogoMIPS: 3456.78
Virtualization: VT-x
L1d cache: 32K
L1i cache: 32K
L2 cache: 256K
L3 cache: 6144K
NUMA node0 CPU(s): 0-7
Configuration...
IRQ information
Hardware Interrupts:
--------------------
IRQ 0: PID: None, count: [43, 43, 43, 43, 43, 43, 43, 43],
Sched None (priority None), drivers: ['timer']
IRQ 1: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['i8042']
IRQ 8: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['rtc0']
IRQ 9: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['acpi']
IRQ 12: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['i8042']
IRQ 16: PID: None, count: [9498, 9498, 9498, 9498, 9498, 9498,
9498, 9498], Sched None (priority None), drivers: ['ehci_hcd:usb1',
'ath9k', 'nvidia']
IRQ 17: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['mmc0', 'hda_intel']
IRQ 19: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['mmc1']
IRQ 23: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['ehci_hcd:usb2']
IRQ 40: PID: None, count: [21305, 21305, 21305, 21305, 21305,
21305, 21305, 21305], Sched None (priority None), drivers: ['hpet2']
IRQ 41: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['hpet3']
IRQ 42: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['hpet4']
IRQ 43: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['hpet5']
IRQ 44: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['hpet6']
IRQ 45: PID: None, count: [1, 1, 1, 1, 1, 1, 1, 1], Sched None
(priority None), drivers: ['sky2']
IRQ 46: PID: None, count: [1856, 1856, 1856, 1856, 1856, 1856,
1856, 1856], Sched None (priority None), drivers: ['xhci_hcd']
IRQ 47: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 48: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 49: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 50: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 51: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 52: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 53: PID: None, count: [0, 0, 0, 0, 0, 0, 0, 0], Sched None
(priority None), drivers: ['xhci_hcd']
IRQ 54: PID: None, count: [889, 889, 889, 889, 889, 889, 889,
889], Sched None (priority None), drivers: ['ahci']
IRQ 55: PID: None, count: [1, 1, 1, 1, 1, 1, 1, 1], Sched None
(priority None), drivers: ['firewire_ohci']
IRQ 56: PID: None, count: [31, 31, 31, 31, 31, 31, 31, 31],
Sched None (priority None), drivers: ['hda_intel']
Software Interrupts:
--------------------
=== REPORT ===
FireWire kernel drivers:
The new FireWire kernel stack is loaded.
This is still kind of experimental. If you encounter problems,
please also check
with the old stack.
------------------------------------------------------------------------------
Keep Your Developer Skills Current with LearnDevNow!
The most comprehensive online learning library for Microsoft developers
is just $99.99! Visual Studio, SharePoint, SQL - plus HTML5, CSS3, MVC3,
Metro Style Apps, more. Free future releases when you subscribe now!
http://p.sf.net/sfu/learndevnow-d2d
_______________________________________________
Alsa-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/alsa-user
