To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=116694
------- Additional comments from [email protected] Sat Feb 19 21:34:02 +0000 2011 ------- I replicated this behavior on a Windows7 machine printing to an HP Color LaserJet CP2020 Series PCL6, using OOo-dev 3.4.0 DEV300m100 (Build:9571) and comparing it to results obtained printing the same document from OOO320m18 (Build:9502). I created and used sample file ooTestSlide.odp to perform these tests, which has pictures in both bottom corners; file is attached to this bug. In both versions, I followed these steps: 0. Uninstall any previously-installed version of Open Office. 1. Install the correct version of Open Office. 2. Launch the newly-installed Open Office, no registration information submitted. 3. Open the test slide file. 4. Select Print... from the File Menu. 5. Select my Printer. 6. Print. No image trimming was evident on-screen; the trimming effect only appeared on paper. Also attached is a scan of the printouts, laid out overlapping, so that you can see the difference. The easiest to distinguish is the lower-lefthand image of the lighthouse, where you can see that the full image has a door inset on a short wall on the extreme left; in the printout via the DEV snapshot, this shortwall and its door do not appear. In the lower-righthand corner, the koala's ear can also be seen to be cut off, but it's a bit harder to distinguish this difference at first glance. --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]
