I believe nobody about anything.
------ Original Message ------
From: [email protected]
To: [email protected]
Sent: 1/6/2017 11:52:33 AM
Subject: Re: [AFMUG] OT LENR
Well, some of them report radiation bursts, gamma ray I think. And
some of them see isotopes in the powder that did not exist before the
reaction. There are nuclear breadcrumbs if you can believe the
reports.
From:Adam Moffett
Sent: Friday, January 6, 2017 9:49 AM
To:[email protected]
Subject: Re: [AFMUG] OT LENR
Sounds like not knowing why it works could be holding us back. It's
hard to optimize a system you don't understand.
So the breakthrough here, if I'm reading it correctly, is that while
they are only getting a modest 1.2x - 1.4x gain in energy they can
build the devices repeatably.
They should stop calling it 'nuclear'. Mysterious Maybe Exothermic
Heater. MMEH. Or maybe just "The Rossi Device".
------ Original Message ------
From: [email protected]
To: [email protected]
Sent: 1/6/2017 11:27:27 AM
Subject: Re: [AFMUG] OT LENR
Some of the people making these devices have gotten 5X the energy they
put in. It is fickle, like cold fusion, which also worked but not at
any level that was usable.
Many of the low tech home experiments have two ceramic tubes, one with
the nickel hydrogen power and the other with some kind inert stuff.
Both tubes are wrapped with the same amount of nichrome wire and both
connected to the same input voltage. Then they run them for days and
use an infra red thermometer. The one with the nickel powder is
hotter. Some of them put a thermocouple on both tubes to measure how
much hotter one is.
The more sophisticated experimenters actually measure the heat energy
is produced, but that is harder to do. Some just estimate the heat
energy by emissivity.
From:Adam Moffett
Sent: Friday, January 6, 2017 9:18 AM
To:[email protected]
Subject: Re: [AFMUG] OT LENR
I guess you mean the category of, "It works, but we don't know why"?
I think on LENR, the physicists are saying, "Yes you have surplus
heat, but for God's sake stop calling in 'nuclear'!"
I know the Rossi LENR device needed electrical input to run a
resistive heater. I think I'm seeing that the surplus heat is
significant, but does anyone say how big the surplus is?
------ Original Message ------
From: [email protected]
To: "Animal Farm" <[email protected]>
Sent: 1/6/2017 10:55:23 AM
Subject: Re: [AFMUG] OT LENR
Lotsa guys won’t believe this. But it is in the same category as
high temp super conductors & EM wave drive.
From:Jaime Solorza
Sent: Friday, January 6, 2017 6:42 AM
To:Animal Farm
Subject: Re: [AFMUG] OT LENR
I know one guy who won't believe this
On Jan 6, 2017 5:22 AM, "Rory Conaway" <[email protected]>
wrote:
At least there may be validation for LENR. Next question is cost
and realistic output for that cost.
Rory
-----Original Message-----
From: Af [mailto:[email protected]] On Behalf Of Chuck McCown
Sent: Thursday, January 5, 2017 8:18 PM
To: [email protected]
Subject: [AFMUG] OT LENR
-----Original Message-----
From: [email protected]
Sent: Thursday, January 05, 2017 2:00 PM
To: [email protected]
Subject: Press Release BERKELEY CLEAN TECHNOLOGY COMPANY ANNOUNCES
BREAKTHROUGH FOR LENR POWER DEVICES
Press Release
BERKELEY CLEAN TECHNOLOGY COMPANY ANNOUNCES BREAKTHROUGH FOR LENR
POWER DEVICES
Controllable-on-Demand, Reproducible, Transportable, Scalable LENR
Validated in Third-Party Tests of Brillouin Energy IPB HHT™ LENR
Reactor
BERKELEY, CA, January 5, 2017 – Researchers at SRI International are
reporting that they have successfully replicated “over unity”
amounts of thermal energy (heat) for Brillouin Energy Corporation’s
most advanced Isoperibolic (“IPB”) Hydrogen Hot Tube™ (HHT™) reactor
test systems based on controlled low energy nuclear reactions
(“LENR”). Researchers at SRI conducted a series of third-party tests
of Brillouin Energy’s IPB HHT™ LENR reactor test systems from March
to December 2016. Dr. Francis Tanzella, principal investigator and
Manager of the Low Energy Nuclear Reactions Program, was assigned to
SRI’s testing of Brillouin Energy’s LENR systems and conducted all
of the third-party validation work.
In its Interim Progress Report, SRI summarizes its extensive testing
of five identical Brillouin Energy metallic reactor cores, which
produced the same over-unity controlled heat outputs, turning the
reaction heat on and off repeatedly. "Brillouin Energy appears to
have achieved its most groundbreaking test results to-date," the
Report states.
Data from the SRI International test runs show LENR heat outputs up
to several watts were repeatedly produced from positive coefficients
of performance (COPs) in the range of 1.2X to 1.45X. The Report
continues that LENR heat was independently validated with positive
COPs is significant:
“The LENR coefficients of performance (COPs) may be considered low
and small scale however, it would be a mistake to discount them, in
light of the accuracy of their calorimetry, the consistent
repeatability of their production, their controllability, and the
reproducibility and refinement of their manufacturing techniques,
specifications, and components, all leading to the same repeated
results. Moreover, the transportability of the system is another
remarkable achievement”.
“By using standard industrial manufacturing processes for our
reactor test systems, we have identified an engineering pathway for
manufacturing Brillouin Energy’s IPB HHT™ reactor prototypes,” said
Robert Godes, Chief Technology Officer and Co-Founder of Brillouin
Energy Corp.
In 2017, Brillouin Energy is continuing its work with SRI
International in the testing process to help it to engineer and
develop its IPB HHT™ reactor test systems, with the goal of evolving
them towards LENR prototype equipment systems, which potentially may
generate commercial scale LENR Heat on demand for industrially
useful applications.
We are on the cusp of a new era of cheap, abundant and reliable
power from LENR technologies, at a time when the United States and
many other countries are re-defining their commitments to mitigate
the impacts from climate change, said Robert W. George, Chief
Executive Officer, Brillouin Energy.
Brillouin Energy’s LENR technology includes a proprietary method of
electrical stimulation of nickel-metal conductors using its Q-Pulse™
control system. The process stimulates the system to produce LENR
reactions, which generate excess heat and helium. The excess heat
produced is a product of hydrogen and a nickel-metal catalyst. The
Q-Pulse™ control system stimulation is the key to maintaining the
reaction. Other than the heat output, there are no (zero) toxic or
CO2 emissions of any kind.
The SRI Interim Progress Report summarizes all of the data and
conclusions from SRI International’s nine months of testing of
Brillouin Energy’s IPB HHT LENR reactor systems. To view the Report,
click on the following link at
brillouinenergy.com/SRI_ProgressReport
<http://brillouinenergy.com/SRI_ProgressReport>.
https://www.lenr-forum.com/forum/index.php/Thread/4795-Press-Release-BERKELEY-CLEAN-TECHNOLOGY-COMPANY-ANNOUNCES-BREAKTHROUGH-FOR-LENR-/
<https://www.lenr-forum.com/forum/index.php/Thread/4795-Press-Release-BERKELEY-CLEAN-TECHNOLOGY-COMPANY-ANNOUNCES-BREAKTHROUGH-FOR-LENR-/>
--
LENR Forum
https://www.lenr-forum.com/forum <https://www.lenr-forum.com/forum>
