The antennas were set to 23 DB antennas and I change them up after I took this picture to 30 DBI dishes that I'm using. It did change the ideal signal but it didn't change the actual signal
Sent from my iPhone > On Oct 17, 2016, at 18:41, Josh Luthman <[email protected]> wrote: > > Do you have your power/antennas set right? Between those two points and the > set power levels you're supposed to see -53... > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > >> On Mon, Oct 17, 2016 at 7:37 PM, Craig House <[email protected]> >> wrote: >> It's always been pretty accurate in the past and I have a pretty wide-open >> view I'm 85 feet up on the water tower that sits on a mountaintop on one end >> and I'm 200 feet up on the building roof top on the other end. The odd part >> is that I am achieving that -65 signal on at least one of the chains. I have >> a feeling that it resting on the top of the tank is possibly causing some >> weird reflection >> >> Sent from my iPhone >> >>> On Oct 17, 2016, at 18:34, Josh Luthman <[email protected]> wrote: >>> >>> Doesn't include land cover I bet >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>> >>>> On Oct 17, 2016 7:25 PM, "Craig House" <[email protected]> wrote: >>>> Wink planner shows that it supposed to be a -65 signal >>>> >>>> Sent from my iPhone >>>> >>>>> On Oct 17, 2016, at 18:20, Josh Luthman <[email protected]> >>>>> wrote: >>>>> >>>>> Plug into LinkPlanner >>>>> >>>>> Josh Luthman >>>>> Office: 937-552-2340 >>>>> Direct: 937-552-2343 >>>>> 1100 Wayne St >>>>> Suite 1337 >>>>> Troy, OH 45373 >>>>> >>>>> >>>>>> On Oct 17, 2016 7:11 PM, "Craig House" <[email protected]> wrote: >>>>>> Very close to the top of the water tower on the remote end. It bottom >>>>>> of the dish is resting on hr tank because the mount wasn't stable enough >>>>>> with all the wind here today 45mph. I'll raise it up and brace the >>>>>> mount tomorrow and see what happens. >>>>>> >>>>>> Sent from my iPhone >>>>>> >>>>>> > On Oct 17, 2016, at 18:03, David Kunat <[email protected]> wrote: >>>>>> > >>>>>> > There are only two polarities on th af-x series. >>>>>> > >>>>>> > The first two are the receive signals at the local device. >>>>>> > >>>>>> > The second two (Rem chain0 and Rem chain 1) are the remote device >>>>>> > receive levels (at the far end of the link). >>>>>> > >>>>>> > Is there something in the way? Are you shooting close to the ground or >>>>>> > close to tree tops on one end? >>>>>> > >>>>>> > >>>>>> > > On Oct 17, 2016, at 2:39 PM, Craig House <[email protected]> >>>>>> > > wrote: >>>>>> > > >>>>>> > > So when you have one chain that shows almost 20 dbi weaker than the >>>>>> > > other 3 how do you tell which end to troubleshoot? I have already >>>>>> > > tried to point both ends better but they are 22 miles apart by air. >>>>>> > > 45 minutes by drive and I dont want to just keep driving and >>>>>> > > climbing if someone can tell me which end has the problem. >>>>>> > > >>>>>> > > Craig >>>>>> > > <link.PNG> >
