You had issues with port negotiation? John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi
-----Original Message----- From: "[email protected]" <[email protected]> Sent: Wednesday, March 4, 2015 6:12pm To: "[email protected]" <[email protected]> Subject: Re: [AFMUG] ePMP Failure You can get the beta but it doesn't have any ethernet fixes. If connecting to Mikrotik, lock both ports down to 100 Mbps FDX and reboot the radio. On Wed, Mar 4, 2015 at 6:11 PM, John Woodfield <[ [email protected] ]( mailto:[email protected] )> wrote: Had to reboot mine. Seems to be ok. Placed on the poe out of the RB2011 so I can remote reboot if needed. 2.3.4 is the newest firmware? John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi -----Original Message----- From: "George Skorup (Cyber Broadcasting)" <[ [email protected] ]( mailto:[email protected] )> Sent: Wednesday, March 4, 2015 1:53pm To: [ [email protected] ]( mailto:[email protected] ) Subject: Re: [AFMUG] ePMP Failure I had an ePMP AP suddenly stop responding last week. Ethernet link showed up. Bounced the MT port and it was restored. Didn't have to power-cycle the radio. On 3/4/2015 8:31 AM, John Woodfield wrote: It started responding to pings again out of nowhere but throwing errors on the switch interface. Going to replace it and the wire Saturday when this weather clears out. Thankful for redundant back hauls Sent from my iPhone On Mar 4, 2015, at 9:29 AM, John Woodfield <[ [email protected] ]( mailto:[email protected] )> wrote: Heading out this afternoon to move to a switchable Poe port. Sent from my iPhone On Mar 4, 2015, at 8:18 AM, [ [email protected] ]( mailto:[email protected] ) <[ [email protected] ]( mailto:[email protected] )> wrote: Have you tried power cycling it? We haven't seen a single ePMP failure. On Wed, Mar 4, 2015 at 7:47 AM, John Woodfield <[ [email protected] ]( mailto:[email protected] )> wrote: Funny thing is I can ping it from the SM side but I can't SSH into it. John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi -----Original Message----- From: "John Woodfield" <[ [email protected] ]( mailto:[email protected] )> Sent: Wednesday, March 4, 2015 7:38am To: [ [email protected] ]( mailto:[email protected] ) Subject: [AFMUG] ePMP Failure Had an ePMP sector we put up a couple months ago. Has been sitting, transmitting with no associations no problem. Put it temporarily in PTP mode last night and cranked the power to 30. It lasted about 12 hours and now I show no link to the switch port. Anybody else have problems killing these with the power cranked up or other reason or is this just a fluke? John Woodfield, President Delmarva WiFi Inc. 410-870-WiFi
