good to know. I didn't think 50v would be a problem, but I didn't want to say so, since I haven't tried.
________________________________ From: Af [[email protected]] on behalf of Josh Reynolds via Af [[email protected]] Sent: Tuesday, October 21, 2014 1:55 PM To: [email protected] Subject: Re: [AFMUG] AF24 power supply for Rocket M5 TI Not a problem. They should run fine on 56v actually. Josh Reynolds, Chief Information Officer SPITwSPOTS, www.spitwspots.com<http://www.spitwspots.com> On 10/21/2014 10:17 AM, That One Guy via Af wrote: Will it hurt the TI to be running off 50v rather than 48? We have a M5TI thats freaking out every night, poor throughput though it shows a good link, high latency, etc. Its getting replaced with a 650 but Im curious if its possible the unit is getting an overvoltage We had to flip flop AP station, when it was AP it would lock up the link, the Station would still show connected, I would have to reboot the station to force it to establish a new link. It is high interference, so that probably it too. On Tue, Oct 21, 2014 at 12:21 PM, Mathew Howard via Af <[email protected]<mailto:[email protected]>> wrote: I have one from a RocketM2 Ti here... it's a UBI-POE-48-5G. pinout is the same, but it's only 48v vs 50v. I suspect it would work fine, but the voltage is a bit higher, so I suppose there's some risk of letting magic smoke out. ________________________________ From: Af [[email protected]<mailto:[email protected]>] on behalf of That One Guy via Af [[email protected]<mailto:[email protected]>] Sent: Tuesday, October 21, 2014 11:14 AM To: [email protected]<mailto:[email protected]> Subject: [AFMUG] AF24 power supply for Rocket M5 TI I have a box of GP-C500-120G power Supplies for air fiber, +(1,2)(4,5) -(7,8)(3,6) 50V Im trying to figure out which power supply is the actual one for M5 TI and if theyre compatible -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925 -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
