Takes time to shift slavk. Sent from my iPhone
> On Jul 3, 2025, at 2:20 PM, Dev <[email protected]> wrote: > > > We had probably 30 extra feet of slack about 250 feet away in a ped, which > was most excellent, since he could pull what was needed to get enough slack > for the splice case. We used an ofdc-b8 splice case. Here’s how it came out > -eventually. > > <Screenshot 2025-07-02 at 4.34.20 PM.png> > >> On Jul 2, 2025, at 2:39 PM, Adam Moffett <[email protected]> wrote: >> >> Some people are faster or slower, but I agree with 45 minutes to get >> prepped. It does depend on the type of cable and type of case. A 12F drop >> going into a Coyote DTC could be prepped in 15 minutes. An OSP cable into a >> FOSC-A case is more like the 45 minutes. Actual splices ought to average >> about 2-2.5 minutes each. If there are multiple buffer tubes you lose some >> time prepping the next tray and tube, so maybe you average more like 3.5 >> minutes, but on a 12F in a single tube I'd lean closer to 2 minutes per >> splice. >> >> That figure puts the actual case and splicing at around 1.25 hours. Moving >> the slack is kind of a wild card. He pulled the slack by himself? He must >> have had to find the right hole, untie the bundle of slack, figure-8 it on >> the ground, pull it to where it was needed, and then go close up that hole. >> Too many variables to say for sure, but I can easily imagine that part >> taking an hour or two. >> >> Basically, I think the splicing is only half of that story and the other >> half is moving the slack. >> >> -Adam > > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
