We have a Cambium 450i 900 powered by a Netonix WS-12-250-DC ("48V"
setting). Works fine. Check the Netonix forum for a list of equipment
verified that can be powered by a Netonix:
https://forum.netonix.com/viewtopic.php?f=6&t=1215
Mike Davis
On 8/2/2018 8:22 AM, Christopher Gray wrote:
Thank you... I was hoping they started doing both like the ePMP line.
It would sure make it easier to transition to Cambium gear.
I have plenty of switched pairs, but they will eventually lead to
fried gear somewhere (when someone makes the mistake of plugging in
the wrong wire).
------------------------------------------------------------------------
On Thu, Aug 2, 2018 at 12:15 AM Mathew Howard <[email protected]
<mailto:[email protected]>> wrote:
No, they will not. They need to have negative on pins 4&5 and
positive on 7&8. It'll work fine if you just swap those two pairs
in one end of the cable.
On Wed, Aug 1, 2018 at 10:23 PM Christopher Gray
<[email protected] <mailto:[email protected]>>
wrote:
Will the PMP 450i 900 MHz SM work with standard polarity? I
understand they work with Cambium polarity from 20-32V, but I
want to run one off a Netonix, and I'm not sure whether I need
to reverse polarity or not.
Thank you - Chris
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
